Patch Antennas with T-Match, Inductively Coupled Loop and Nested-slots Layouts for Passive UHF-RFID Tags
| Authors | Hind Raihani1, Ali Benbassou1, Mohammed El Ghzaoui1 , 2 , Jamal Belkadid1, Sudipta Das3 |
| Affiliations |
1Inn. Laboratory, EST-Fez, Sidi Mohamed Ben Abdellah University, Morocco 2Sidi Mohamed Ben Abdellah University, Faculty of Sciences, Fes, Morocco 3Department of ECE, IMPS College of Engineering and Technology, W.B., India
|
| Е-mail | |
| Issue | Volume 13, Year 2021, Number 3 |
| Dates | Received 15 January 2021; revised manuscript received 14 June 2021; published online 25 June 2021 |
| Citation | Hind Raihani, Ali Benbassou, Mohammed El Ghzaoui, et al., J. Nano- Electron. Phys. 13 No 3, 03033 (2021) |
| DOI | https://doi.org/10.21272/jnep.13(3).03033 |
| PACS Number(s) | 84.40.Ba |
| Keywords | RFID (2) , Antenna (6) , UHF-RFID, T-Match, Inductively couped loop, Nested slots. . |
| Annotation |
The objective of this article is to study the performance of the RFID (Radio Frequency Identification) technology and especially the passive UHF RFID (Ultra High Frequency RFID) tags by mean of simulation. In this paper, three patch antennas with different matching techniques for passive UHF-RFID tags are proposed. T-Match, inductively coupled loop and nested-slots layouts are adopted in order to achieve complex impedance matching between the antennas impedance and the chip selected at 915 MHz with high performance. The antennas are printed on a Rogers RT/duroid 5880 substrate with a relative permittivity of 2.2 and thickness of 1.575 mm. Studies demonstrate that the inductively coupled loop and the nested-slots matching techniques are the good candidates to adapt the antenna impedance to chip impedance, while adaptation in T is intended to be only used for dipole antennas. We have achieved an adaptation of 99.90 %, a very wide bandwidth of 409.6 MHz, a broadside an asymmetrical radiation pattern in the E-plane, a read range of 21.19 m and an antenna gain of 4.17 dB with the inductively coupled loop matching technique, while with the nested-slots matching method, we have acquired an adaptation of 99.94 %, a directive antenna, a read range of 19.83 m and a gain of 3.59 dB. |
|
List of References |
Other articles from this number
1) Compact Dual Wideband Open-Ended Ring Shaped Slot Loaded Printed Monopole Antenna for X Band Applications [03001-1-03001-4]2) Antibacterial and Optical Activities of Microwave Aided Zn2SnO4 Nanorods [03002-1-03002-4]
3) Preparation and Studies on ZnO Nanoparticles Doped with Ni, Ca and Fe [03003-1-03003-5]
4) ALD Grown Al2O3 as Interfacial Layer in ITO Based SIS Solar Cells [03004-1-03004-4]
5) Performance Analysis of Wireless Power Transfer System for Office Communications [03005-1-03005-4]
6) Sizing Optimization of Grid-Connected Hybrid PV-Wind Energy Systems: State of Art Review and Perspectives [03006-1-03006-4]
7) Design and Implement of Dual-axis Solar Tracker in Comparison to Fixed Panel System [03007-1-03007-4]
8) Mixed Convection Inside a Cavity Incorporating Cu-H2O Nanofluid with Conducting Cylinders Placed at Optimum Position [03008-1-03008-4]
9) Impact of Absorbing Layer Band Gap and Light Illumination on the Device Performance of a Single Halide Cs2TiX6 Based PSC [03009-1-03009-4]
10) Comprehensive Analytical Modeling of AlGaN/GaN based Heterostructure Gas Sensor [03010-1-03010-5]
11) Optimization, Sensitivity and Energy Management of a PV/Wind/Battery and PV/Wind/Supercapacitor Hybrid Renewable Energy System for the Climatic Conditions of Haldia using HOMER: A Case Study [03011-1-03011-5]
12) Modeling of Catalyst Layer for PEM Fuel Cell: MATLAB Approach [03012-1-03012-5]
13) Investigations on the Optical-Electrical-Thermal Characteristics of RGB LEDs [03013-1-03013-4]
14) Utility of a Reverse Double-drift Structure for Fabricating GaN IMPATT Diode Operating in the Terahertz Regime [03014-1-03014-4]
15) Effect of High-k Dielectric Materials on Short Channel Effects of a 14 nm Tri-Gate SOI FinFET for Reduced Area on Chip [03015-1-03015-4]
16) Oxidative Synthesis of Activated Carbon from Low-grade Indian Tertiary Coal and Its Chemical Characterization [03016-1-03016-4]
17) Synthesis of Mixed-phase Barium Titanium Oxide (BaTiO3/Ba2TiO4) Perovskite Catalyst for Biofuel Production [03017-1-03017-4]
18) Studies on Thickness and Internal Quantum Efficiency of Cs2AgBiBr6 Based Double Perovskite Material for Photovoltaic Application [03018-1-03018-4]
19) Simulation study of Formamidinium Lead Halide (FAPbX3; X = I and Br) Based Perovskite Solar Cells Using SCAPS-1D Device Simulator [03019-1-03019-4]
20) Influence of Triple Material on Performance Study of Double Gate PiN Tunneling Graphene Nanoribbon FET for Low Power Logic Applications [03020-1-03020-4]
21) Design and Realization of a Fuzzy Controller for Diabetes Type 1 [03021-1-03021-4]
22) Bianchi Type VI Inflationary Cosmological Model with Massive String Source in General Relativity [03022-1-03022-5]
23) An Innovative Approach of Renewable Energy Management Using Fuzzy Technique [03023-1-03023-5]
24) An Advanced Method to Fuzzy Logic Based on Hybrid Renewable Power Optimization, Real Time Application [03024-1-03024-5]
25) Investigation of the Capacitive Properties of Chemically Activated Sugarcane Bagasse Biochar for Supercapacitor Application [03025-1-03025-5]
26) Design of Compact UWB Slotted Hexagonal Monopole Antenna with 3.5/5.5 GHz Dual Band Rejection [03026-1-03026-4]
27) Preliminary Study of Electrochemical Behavior of Ketjen Black Modified Glassy Carbon Electrode (GCE) in Dopamine Solution [03027-1-03027-3]
28) A 3D Printed 2x2 Circular Planar Antenna Array for Wireless Communications Applications [03028-1-03028-4]
29) Compact Circular Ring Antenna for 5G Mobile Communication Applications [02029-1-02029-4]
30) A Novel Security Unit with Mitigating Frequency Deviation for Interconnected Power System Considering Cyberattack [03030-1-03030-4]
31) Fuzzy Logic Controller Design for Voltage, Frequency, Current and Power Control of Three-phase Distributed Generation Based Islanded Microgrid [03031-1-03031-4]
32) Modeling and Characteristics of a 3 dB Hybrid Coupler for 5G Applications [03032-1-03032-5]
33) The Production of High Phycocyanin by Applications of Red Light-Emitting Diodes (LEDs) In Vitro Algae Growth on Spirulina platensis [03034-1-03034-4]
34) Performance Analysis of Oversampled OFDM over PLC Network [03035-1-03035-5]
35) Investigation of Equivalent Circuit Model for a 5G Microstrip Patch Antenna [03036-1-03036-4]
36) Design of Dual-Polarized Compact Quad Band Metamaterial Antenna [03037-1-03037-4]
37) Optimum Sliding Wear Parameters for Minimum Volumetric Wear of Silica Filled Resin Based Dental Composites [03039-1-03039-4]
38) A Novel Approach Towards Green Synthesis of Nanodiamonds as Biocompatible Agents [03040-1-03040-6]
39) Ab-initio Calculation Study of Electronic Band Structure of CdTe with Low-index Surface [03041-1-03041-5]
40) Structure and Magnetoresistive Properties of Three-layer Films Сo(1 – x)Crx/Cu/Co [03042-1-03042-4]
