Compact Circular Ring Antenna for 5G Mobile Communication Applications
| Authors | Sarah A. Alassawi1, Wael A.E. Ali2 , Mohamed R.M. Rizk3 |
| Affiliations |
1Electronics & Comm. Engineering Department, College of Engineering, Higher Institute of Engineering and Technology, King Marriott, Alexandria, Egypt 2Electronics & Comm. Engineering Department, College of Engineering, Arab Academy for Science, Technology and Maritime Transport (AASTMT), Alexandria, Egypt 3Electrical Engineering Department, Alexandria University, Alexandria, Egypt |
| Е-mail | sarah.elesawy@gmail.com |
| Issue | Volume 13, Year 2021, Number 3 |
| Dates | Received 21 March 2021; revised manuscript received 15 June 2021; published online 25 June 2021 |
| Citation | Sarah A. Alassawi, Wael A.E. Ali, et al., J. Nano- Electron. Phys. 13 No 3, 03029 (2021) |
| DOI | https://doi.org/10.21272/jnep.13(3).03029 |
| PACS Number(s) | 84.40.Ba |
| Keywords | MMW, Monopole antenna (2) , 5G mobile application, 60 GHz, Circular ring antenna, High frequency structure simulator (HFSS). |
| Annotation |
This paper presents another alternative design of monopole microstrip patch antenna for millimeter wave (MMW) short range wireless communications applications. The purpose of this paper is to discuss a new design of antenna that operates in the MMW frequency range at 60 GHz. The design is based on single element with full size of 9 11 mm2 that contains two elliptical loops monopole antenna and a line feed of 50 ohm on the top layer of substate with a partial ground plane on the opposite side. Microstrip-patch antenna has been designed and implemented for 5G wireless communication technology at 60 GHz with low-cost and small size substrate that makes it suitable for small devices. In the proposed design, the used substrate material is Roger RT6035htc lossy with relative dielectric 3.5 and loss tangent 0.0013 with partial ground plane to improve the impedance characteristics. The designed antenna provides a uniform current distribution over the surface of antenna at the resonance frequency with an acceptable realized gain of 4.8 dBi in the far-zone with a return loss reaches up to – 33 dB. The simulation results are carried out using high frequency structure simulator (HFSS), FEM is based on full 3D wave electromagnetic solver simulator from Analysis and the obtained results confirm the suitability of the proposed MMW antenna to be a good candidate for 5G applications. |
|
List of References |
Other articles from this number
1) Compact Dual Wideband Open-Ended Ring Shaped Slot Loaded Printed Monopole Antenna for X Band Applications [03001-1-03001-4]2) Antibacterial and Optical Activities of Microwave Aided Zn2SnO4 Nanorods [03002-1-03002-4]
3) Preparation and Studies on ZnO Nanoparticles Doped with Ni, Ca and Fe [03003-1-03003-5]
4) ALD Grown Al2O3 as Interfacial Layer in ITO Based SIS Solar Cells [03004-1-03004-4]
5) Performance Analysis of Wireless Power Transfer System for Office Communications [03005-1-03005-4]
6) Sizing Optimization of Grid-Connected Hybrid PV-Wind Energy Systems: State of Art Review and Perspectives [03006-1-03006-4]
7) Design and Implement of Dual-axis Solar Tracker in Comparison to Fixed Panel System [03007-1-03007-4]
8) Mixed Convection Inside a Cavity Incorporating Cu-H2O Nanofluid with Conducting Cylinders Placed at Optimum Position [03008-1-03008-4]
9) Impact of Absorbing Layer Band Gap and Light Illumination on the Device Performance of a Single Halide Cs2TiX6 Based PSC [03009-1-03009-4]
10) Comprehensive Analytical Modeling of AlGaN/GaN based Heterostructure Gas Sensor [03010-1-03010-5]
11) Optimization, Sensitivity and Energy Management of a PV/Wind/Battery and PV/Wind/Supercapacitor Hybrid Renewable Energy System for the Climatic Conditions of Haldia using HOMER: A Case Study [03011-1-03011-5]
12) Modeling of Catalyst Layer for PEM Fuel Cell: MATLAB Approach [03012-1-03012-5]
13) Investigations on the Optical-Electrical-Thermal Characteristics of RGB LEDs [03013-1-03013-4]
14) Utility of a Reverse Double-drift Structure for Fabricating GaN IMPATT Diode Operating in the Terahertz Regime [03014-1-03014-4]
15) Effect of High-k Dielectric Materials on Short Channel Effects of a 14 nm Tri-Gate SOI FinFET for Reduced Area on Chip [03015-1-03015-4]
16) Oxidative Synthesis of Activated Carbon from Low-grade Indian Tertiary Coal and Its Chemical Characterization [03016-1-03016-4]
17) Synthesis of Mixed-phase Barium Titanium Oxide (BaTiO3/Ba2TiO4) Perovskite Catalyst for Biofuel Production [03017-1-03017-4]
18) Studies on Thickness and Internal Quantum Efficiency of Cs2AgBiBr6 Based Double Perovskite Material for Photovoltaic Application [03018-1-03018-4]
19) Simulation study of Formamidinium Lead Halide (FAPbX3; X = I and Br) Based Perovskite Solar Cells Using SCAPS-1D Device Simulator [03019-1-03019-4]
20) Influence of Triple Material on Performance Study of Double Gate PiN Tunneling Graphene Nanoribbon FET for Low Power Logic Applications [03020-1-03020-4]
21) Design and Realization of a Fuzzy Controller for Diabetes Type 1 [03021-1-03021-4]
22) Bianchi Type VI Inflationary Cosmological Model with Massive String Source in General Relativity [03022-1-03022-5]
23) An Innovative Approach of Renewable Energy Management Using Fuzzy Technique [03023-1-03023-5]
24) An Advanced Method to Fuzzy Logic Based on Hybrid Renewable Power Optimization, Real Time Application [03024-1-03024-5]
25) Investigation of the Capacitive Properties of Chemically Activated Sugarcane Bagasse Biochar for Supercapacitor Application [03025-1-03025-5]
26) Design of Compact UWB Slotted Hexagonal Monopole Antenna with 3.5/5.5 GHz Dual Band Rejection [03026-1-03026-4]
27) Preliminary Study of Electrochemical Behavior of Ketjen Black Modified Glassy Carbon Electrode (GCE) in Dopamine Solution [03027-1-03027-3]
28) A 3D Printed 2x2 Circular Planar Antenna Array for Wireless Communications Applications [03028-1-03028-4]
29) A Novel Security Unit with Mitigating Frequency Deviation for Interconnected Power System Considering Cyberattack [03030-1-03030-4]
30) Fuzzy Logic Controller Design for Voltage, Frequency, Current and Power Control of Three-phase Distributed Generation Based Islanded Microgrid [03031-1-03031-4]
31) Modeling and Characteristics of a 3 dB Hybrid Coupler for 5G Applications [03032-1-03032-5]
32) Patch Antennas with T-Match, Inductively Coupled Loop and Nested-slots Layouts for Passive UHF-RFID Tags [03033-1-03033-5]
33) The Production of High Phycocyanin by Applications of Red Light-Emitting Diodes (LEDs) In Vitro Algae Growth on Spirulina platensis [03034-1-03034-4]
34) Performance Analysis of Oversampled OFDM over PLC Network [03035-1-03035-5]
35) Investigation of Equivalent Circuit Model for a 5G Microstrip Patch Antenna [03036-1-03036-4]
36) Design of Dual-Polarized Compact Quad Band Metamaterial Antenna [03037-1-03037-4]
37) Optimum Sliding Wear Parameters for Minimum Volumetric Wear of Silica Filled Resin Based Dental Composites [03039-1-03039-4]
38) A Novel Approach Towards Green Synthesis of Nanodiamonds as Biocompatible Agents [03040-1-03040-6]
39) Ab-initio Calculation Study of Electronic Band Structure of CdTe with Low-index Surface [03041-1-03041-5]
40) Structure and Magnetoresistive Properties of Three-layer Films Сo(1 – x)Crx/Cu/Co [03042-1-03042-4]
