Improving the Wear Resistance of Thermally Sprayed Nanocomposite Cr3C2-25NiCr Coatings by Pulsed Plasma Treatment

Автори M.G. Kovaleva1, V.V. Sirota2, V.M. Beresnev3, Yu.N. Tyurin4, O.N. Vagina1, I.A. Pavlenko1
Приналежність

1Belgorod National Research University, 85, Pobedy Str., 308015 Belgorod, Russia

2Belgorod State Technological University named after V.G. Shoukhov, 46, Kostyukov Str., 308012 Belgorod, Russia

3V.N. Karazin Kharkiv National University, 4, Svobody Sq., 61000 Kharkiv, Ukraine

4O. Paton Electric Welding Institute, NASU, 11, Bozhenko Str., 03650 Kyiv, Ukraine

Е-mail Kovaleva@bsu.edu.ru
Випуск Том 10, Рік 2018, Номер 6
Дати Одержано 04.10.2018; у відредагованій формі 03.12.2018; опубліковано online 18.12.2018
Посилання M.G. Kovaleva, V.V. Sirota, V.M. Beresnev, et al., J. Nano- Electron. Phys. 10 No 6, 06035 (2018)
DOI https://doi.org/10.21272/jnep.10(6).06035
PACS Number(s) 68.37.Hk, 68.37.Yz, 62.20.Qp
Ключові слова Hardmetal coating, Chromium carbide, Multi-chamber gas-dynamic accelerator (2) , Pulsed plasma treatment, Wear resistance (2) .
Анотація

In this study the surfaces of thermally sprayed nanocomposite Cr3C2-25NiCr coating have been treated by the pulsed plasma. The nanocomposite Cr3C2-25NiCr coating was deposited by a new multi-chamber gas-dynamic accelerator on grit blasted steel substrate. An automatic pulse-plasma device “Impulse-6” was employed to plasma treatment the surface of Cr3C2-25NiCr coating. The microstructure and wear resistance of the surface of the nanocomposite Cr3C2-NiCr coating before and after the pulsed plasma treatment (PPT) was studied in this paper. Wear tests were carried out using a computer controlled pin-on-disc type tribometer at 25 ºC. The specific wear rate of the nanocomposite Cr3C2-25NiCr coating after PPT is approximately four times less than that of the Cr3C2-25NiCr coating before PPT, indicating that the nanocomposite Cr3C2-25NiCr coating after PPT exhibits better wear resistance. Detailed analysis indicates that the enhanced wear resistance of the nanocomposite Cr3C2-25NiCr coating after PPT is mainly attributed to the formation of an oxide tribolayer and smoother surface, which result from the dense and amorphous microstructure of the coating.

Перелік посилань