Автори | M.G. Kovaleva2, M.S. Prozorova2, M.Yu. Arseenko2, M.N. Yapryntsev2, K.N. Mamunin2, V.V. Sirota2, A.Y. Altukhov1 , E.V. Ageev1 |
Афіліація | 1 Southwest State University, 94, 50 Let Oktyabrya st., 305040, Kursk, Russia 2 Belgorod National Research University, 85, Pobedy st., 308015 Belgorod, Russia |
Е-mail | |
Випуск | Том 8, Рік 2016, Номер 3 |
Дати | Одержано 18.05.2016, опубліковано online - 03.10.2016 |
Цитування | M.G. Kovaleva, M.S. Prozorova, M.Yu. Arseenko, et al., J. Nano- Electron. Phys. 8 No 3, 03018 (2016) |
DOI | 10.21272/jnep.8(3).03018 |
PACS Number(s) | 68.37.Hk, 68.37.Yz, 62.20.Qp |
Ключові слова | Alumina–titania coatings, Multi-chamber gas-dynamic accelerator (2) , Microstructure (21) , Hardness (12) . |
Анотація | The aim of the study was to characterize alumina-titania (Al2O3:Ti wt ratio 87:13) coatings were deposited by a new multi-chamber gas-dynamic accelerator on a grit blasted steel substrate. The alumina-titania coatings were characterized using scanning electron microscopy, X-ray diffraction techniques and Vickers hardness tester at a test load 200 g. The coating was well-adhered onto corrosion-resistant steel substrate. Obtained coatings possessed a unique microstructure consisting of fully melted regions with the microstructure similar to a typical thermal sprayed lamellar morphology and areas comprising unmelted or partially melted particles. The dense alumina-titania coatings with hardness of 657 ± 70 HV0.2 and porosity of less than 0.6% have been prepared by a new multi-chamber gas-dynamic accelerator. |
Перелік цитувань |